FAQ: Aviation What Does Advise On Initial Contact Mean?

How do I make initial contact with ATC?

Initial Contact

  1. Who you are talking to: State the identifier of the station or facility you are calling.
  2. Who you are: State who you are (your aircraft make and full tail number.
  3. Where you are: State where you are currently located.
  4. What you want: State the reason for your radio contact.

When initiating contact with ATC How will you identify yourself on the radio?

In your first contact with someone, you identify yourself by aircraft make and tail number, e.g. “Arrow 173ND,” or “Katana 505EC.” In future communication, the tail number gets abbreviated to just the last three numbers/letters, if there is no confusion with any other similarly-tailed aircraft.

What do pilots mean when they say information?

The letters refer to ATIS information, which stands for Automatic Terminal Information Service. ATIS messages are broadcast on a loop on a separate frequency from approach and tower frequencies and inform pilots of weather conditions, active runways, runway conditions, and other important data.

You might be interested:  Question: What Is Vfr Mean In Aviation?

What do you say to approach a controller?

(a) When operating in a radar environment: On initial contact, the pilot should inform the controller of the aircraft’s assigned altitude preceded by the words “level,” or “climbing to,” or “descending to,” as appropriate; and the aircraft’s present vacating altitude, if applicable.

What to say to ATC when taking off?

Phrases tower controllers say:

  1. “Line up and wait” (taxi onto the runway and wait for a takeoff clearance)
  2. “Cleared to cross runway two seven” (taxi across runway 27)
  3. “Fly heading two three zero, Runway two seven Left, Cleared for takeoff” (After takeoff, fly a magnetic heading of 230º.

What is the proper phraseology to say the altitude 10000?

Confusing Phraseology ‘ Phraseology contributed to this incident.” “To correct future problems like this, the altitude should be given in the form of ‘ ten thousand ‘ or ‘eleven thousand’, instead of saying ‘one-zero’, or ‘one-one-thousand. ‘ There is too much of a chance of error.

How does ATC communicate with pilot?

The most common form of communication in aviation, very high frequency (VHF) radio calls are what we use for around 95% of our communications with ATC. In simplified terms, the transmitting station sends a signal that travels in a straight line and is picked up by the receiving station.

When should I contact ATC center?

You must contact this active ATC: When ATC requests so, with receiving a message via IVAO pilot interface. 2 minute before entering the aerodrome circuit or an aerodrome controlled area (CTR)

What does Niner Niner mean?

Aviators often speak “pilot English” to avoid miscommunications over radio transmission. “Tree” for instance, means three, “fife” is the number five and “ niner ” means nine, says Tom Zecha, a manager at AOPA.

You might be interested:  Question: How To Achieve Success Aviation?

Do fighter pilots wear diapers?

Male fighter pilots use something called a “piddle pack”, which is a bag filled with absorbent gel. When the need strikes, they unzip and pee.

Why do pilots say uhh?

Guilty. I’ve always heard/believed, not just in th aviation world, that it’s an old crutch to prevent the beginning of a received transmission from being missed — by using a throwaway word like “and” or ” uhh ” to give the receiver something to break squelch before any actual info is transmitted.

Is air traffic controller a good job?

Air traffic controllers, who maintain the flow of aircraft in and out of airports and in flight, are key to aviation safety. This is well recognized as one of the most stressful jobs, requiring total concentration. Median annual wages of air traffic controllers in May 2008 were $111,870.

Leave a Reply